Kodak DryView 8300 Service Manual page 169

Section 7 - - Troubleshooting
7-1. Testing
You can do troubleshooting by using tests from the LOCAL PANEL or SERVICE COMPUTER. The tests
on the SERVICE COMPUTER can be done either locally or from a remote site.
7-1-1. Testing from the LOCAL PANEL
1. Enter the LOCAL PANEL Test Menu:
a. Press TEST.
b. Type: 911
c. Press [ENTER]
Note
The first item in a series of menu items displays.
2. See Table 7-1 for the sequence of tests on the LOCAL PANEL.
4. EXAMINE SYSTEM ERROR LOG
ENTER TO VIEW OR ARROW FOR OTHER ITEMS
INSTALL DATE
EXPOSURES:
DATE TIME COUNT:
CALIBRATION FAILURE (69)
2. PERFORM SYSTEM DIAGNOSTIC TEST
ENTER TO START OR ARROW FOR OTHER ITEMS
3. PERFORM STORED PATTERN TEST
ENTER TO SETUP OR ARROW FOR OTHER ITEMS
MODULE = A
ENTER TO CHANGE OR ARROW FOR OTHER ITEMS
1. MODULE = A
TO CHANGE PRESS ARROW, THEN ENTER
2. FORMAT = 2 ON 1
ENTER TO CHANGE OR ARROW FOR OTHER
ITEMS
2. FORMAT = 2 ON 1
TO CHANGE PRESS ARROW, THEN ENTER
3. PRINT MODE = SINGLE
ENTER TO CHANGE OR ARROW FOR OTHER
ITEMS
2004 December Rev. S
Table 7-1. Menu Items for LOCAL PANEL Tests
Menu Display
TIME TODAY'S DATE
TOTAL ERRORS:
#: A 01
1908110
Options/Actions
Provides the last 50 errors.
In # = the MODULE. Can be A or B.
01=the count of accumulated errors.
This test is the same as the Power--On
self test. The test runs until completed.
Toggles between modules A and B.
The selections are : 1 on 1
2 on 1
4 on 1
6 on 1
Toggles between Single or Continuous
TROUBLESHOOTING
7-1