Kodak DryView 8300 Service Manual page 173

DL[0] = 5.0000
DH[0] = 217.0000
DENSITOMETER LAMP is Alive
PRFEEDTS: Feed try 1
PRFEEDTS: Film count incremented by 1; one sheet fed
Lamp D/A value = -588
DL[1] = 35.0000
DH[1] = 1462.0000
PRMONCMP: Film at capstan entry and in one sheet switch
PRMONCMP: Film trailing edge out of one sheet switch
PRFEEDTS: Films fed from this package = ?11
Lamp D/A value = 1712
DL[2] = 93.0000
DH[2] = 3878.0000
LAMP D/A value = 20112
LAMP max brightness =
LAMP D/A value = 19952
LAMP fine tuned max brightness =
offset low
5.0000
offset high
217.0000
gain high
41.6552
To establish a baseline with no film in the internal DENSITOMETER, its LAMP has just been ramped
up to maximum brightness, which is read by its SENSOR. Next, when film has been detected by the
PROCESSOR ENTRANCE SWITCH SENSOR, the DENSITOMETER gets ready to read the film.
DT_READ: Waiting for film at PROCESSOR entry
DT_READ: Waiting for leading black film border
PRPRCTSK: Film in PROCESSOR entry
PREXPTSK: Film trailing edge out of CAPSTAN
PRHTCTRZ: Recovered after
PRPRCTSK: PROCESSOR ENTRY SWITCH cleared
DT_READ: Leading black film border detected
PRPRCTSK: Film in PROCESSOR exit
PRPRCTSK: Film trailing edge at exit
PRPRCTSK: Page finished Printing
Lamp Reading Before Film Arrives
4069
gain low
4064.0000
2344 Calibration Wedge Samples
2004 December Rev. S
4095
4083
5 RTD values were filtered out
1908110
TROUBLESHOOTING
27 AUG 03 09:08:07
27 AUG 03 09:08:10
27 AUG 03 09:08:12
27 AUG 03 09:08:18
27 AUG 03 09:08:18
27 AUG 03 09:08:48
27 AUG 03 09:09:26
27 AUG 03 09:09:27
27 AUG 03 09:09:33
27 AUG 03 09:09:49
27 AUG 03 09:09:58
27 AUG 03 09:10:05
27 AUG 03 09:10:06
27 AUG 03 09:10:28
27 AUG 03 09:10:28
7-5