Adjustment for the One-Pad Stripper Assembly
Note
The stripper gap is changed by adjusting the position of the roller assemblies located at each end of
the stripper. Adjust one roller assembly at a time. Recheck the measurement after each adjustment.
1. Loosen the roller assembly securing screws.
2. Insert a flat screwdriver in the adjustment slot.
3. On the left side, rotate the screwdriver clockwise to increase the gap and counterclockwise to
decrease it. (On the right side, rotate the screwdriver counterclockwise to increase the gap and
clockwise to decrease it.)
4. Tighten the roller assembly securing screws.
5. Recheck the measurement.
2004 December Rev. S
1908110
Top View from Front
Adjustment Slot
Roller Assembly
Figure 3-4.
ADJUSTMENTS
8300- -19C
3-5