Kodak DryView 8300 Service Manual page 25

Parameter
8. CALIBRATION ENABLE
9. MODULE ID
10. EXPOSURES
11. CAL PROCESSOR CENTER
TEMP
1. MEASURED CENTER
ZONE READING
12. CAL PROCESSOR END
TEMP
1. MEASURED END
ZONE READING
13. ENERGY SAVER OPTION
14. IMAGE VIEWING
15. DIGITAL INTERFACE
1. PARITY
16. MODALITY GROUP
17. PM EXPOSURES
18. FILM COUNT ENABLE
(effective with Version 4.9)
2004 December Rev.S 1908110
Options Action
ON or OFF Leave at ON (default). Allows a calibration to be
done when the film TRAY is inserted, if a print is
requested after the IMAGER is not used for 8
hours, and when the IMAGER is energized.
INPUT MODULE Provide the INPUT MODULE with another
can be given name, not more than 8 characters, if necessary.
another name for Use the instructions in the "Module ID" menu.
local display.
None. Do not change. The number of exposures
indicates the total film count processed by the
CPU BOARD in the IMAGER.
None. Do not adjust at installation. Current
temperature is displayed and can range from
112.8 -- 140.6° C. This parameter is used in the
procedure for Setting Up the Processor
Temperature.
None. Same as above.
ON or OFF Leave at OFF. If set to ON, HEATERS and
MOTORS will de-energize after 3 hours if the
IMAGER has not been used. The 3 hours is not
programmable.
EMULSION or AH Leave at EMULSION.
(anti-halation)
NONE, EVEN, or Use the menu instructions to set the data parity.
ODD Start with "None".
0 -- 4 Defaults to Group 0. See paragraph 2-13.
Set to 0 at Reset to 0 when PM has been completed.
installation. "SCHEDULE PM" message will be removed
Causes from LOCAL PANEL.
"SCHEDULE PM"
to be displayed on
the LOCAL
PANEL when
10,000 films have
been printed.
ON or OFF Set to ON to allow the number of remaining
films in the FILM TRAY to be displayed on the
LOCAL PANEL.
INSTALLATION INSTRUCTIONS
2-7