Kodak DryView 8300 Service Manual page 37

Parameter
1. ASPECT RATIO
4. NETWORK INTERFACE
1. ADDR
2 IP ADDRESS SOURCE
3. IP ADDR
4. NET MASK
5. CONNECTOR
6. ROUTER
2004 December Rev.S 1908110
Table 2-5. Setting the Network Installation Parameters
Options
0.50 to 2.00
None (MAC Address)
Local or RARP server.
Assigned by customer.
Assigned by customer.
10BaseT
Assigned by customer, if
required.
INSTALLATION INSTRUCTIONS
Action
Set to 1.0, which checks that the
pixel aspect ratio values
communicated through DICOM
are correct. After acquiring a first
image, changes to this value
may be necessary.
Do not change. Leave at default
value.
Use the menu instructions to
indicate if the address is entered
locally, or automatically by a
RARP server.
Use the menu instructions to
enter the IP address provided by
the customer's network
administrator. If one is not
provided, set the address source
to RARP in menu item 2.
Use the menu instructions to
enter the Net Mask provided by
the customer's network
administrator. The value is
entered in decimal format where
255 decimal = FF hexadecimal. If
the customer uses hexadecimal,
FFFFFF00 would =
255.255.255.0.
Use the menu instructions to
select 10BaseT modular Telco
type CONNECTOR only. A BNC
connection is currently not
available.
Enter the Router Address
provided by the customer's
network administrator.
This parameter is the gateway to
other subnets, and might be
necessary if the MODALITY is
not located on the same subnet
as the IMAGER.
2-19