Kodak DryView 8300 Service Manual page 65

15. Allow the block to initially rest squarely in the slot, and then read the measured temperature on the
TEMPERATURE METER. Slowly rock the block slightly in one direction until the highest temperature
reading is obtained. Use this reading in step 17.
16. On the local panel, access the Cal Processor Center Temp submenu under the Installation menu.
17. Set the temperature displayed on the local panel to match the maximum temperature reading
displayed on the meter.
18. Continue monitoring the temperature for approximately five minutes to ensure that the temperature
change is taking effect.
Note
To display an updated temperature reading on the local panel, exit and re-enter the Cal Processor
Center Temp submenu.
19. Once the center temperature has stabilized, remove and clean the probe. Wait a full five minutes
before proceeding.
!
Caution
To prevent damage to the surface of the processor drum, remove and clean the probe after taking
each temperature reading.
20. Repeat steps 13 through 18, but align the edge of the probe this time with the left edge of the
processor entrance chute (refer to Figure 3-2), and access the Cal Processor End Temp submenu on
the local panel.
Note
Do not attempt to take a temperature reading at the right end of the processor. The probe will
interfere with the processor entrance switch.
21. Once the left end temperature has stabilized, remove and clean the probe. Wait a full five minutes
before proceeding.
22. Re-check the center zone temperature. If the local panel and meter readings differ by more than one
degree, repeat steps 13 through 22.
23. Remove the safety interlock defeat mechanism.
24. Reconnect the mechanical processor drive arm to the top cover push rod. Replace the left side panel.
Close the top cover and install the film tray.
25. From the local panel, enable Film Calibration.
2004 December Rev. S 1908110
ADJUSTMENTS
3-3