Kodak DryView 8300 Service Manual page 31

Parameter
15. 640 X 480
(ATL)
16. 580 X 480
(ATL)
Note
If 3M protocol is selected, options 1--4 or the SERIAL CONTROL INTERFACE become available.
3. SERIAL CONTROL
INTERFACE:
1. BAUD RATE
2. NUMBER OF DATA BITS
3. NUMBER OF STOP BITS
4. PARITY
5. DELIMITER
6. IGNORE LATE ACK/NAK
7. PROTOCOL
6. MARK INSTALL DATE
7. MEMORY MANAGEMENT
8. CALIBRATION ENABLE
9. MODULE ID
10. EXPOSURES
2004 December Rev.S 1908110
Options
For default values, press ENTER. Press
[EXIT] if you do not want to make changes.
For default values, press ENTER. Press
[EXIT] if you do not want to make changes.
To change settings:
1200, 2400, 4800, Select between baud rates.
9600, or 19200
7 or 8 Select the data bit settings for selected
value.
1 or 2 Select the stop bit setting for selected
value.
ODD, EVEN, or Select the parity setting between selections.
NONE
Comma or space. Select between options, for host
requirements to separate DZO commands.
ON or OFF. Set to ON if the host device is a Kodak
PACS Link 9410 ACQUISITION SYSTEM.
3M (Host) or Select the "Control Protocol" setting
KEYPAD between options.
Date of install: If date is incorrect, change Date/Time
parameter in the "General Setup" menu.
day/month/year
A = 4.0 MB Partition memory across 2 INPUT
MODULES as necessary. If only 1
B = 4.0 MB
MODULE is used, all memory should be set
to it. See paragraph 2--6 for setting up
memory parameters.
ON or OFF Leave at ON (default). Allows a calibration
to be done when the film TRAY is inserted,
if a print is requested after the IMAGER is
not used for 8 hours, and when the
IMAGER is energized.
Input module can Provide the INPUT MODULE with another
be renamed for the name, not more than 8 characters, if
local display. necessary. Use the instructions in the
"Module ID" menu.
None. Do not change. The exposure number
indicates the total film count processed by
the CPU BOARD in the IMAGER.
INSTALLATION INSTRUCTIONS
Action
2-13