Kodak DryView 8300 Service Manual page 46

SERVICE MANUAL
10. From the "Service Test" menu, check that the Service Port Baud Rate is set to match the terminal
program baud rate (e.g. 38.4 K BPS).
11. From the SERVICE COMPUTER, to check the connection, type: @ and the Error Log from the
IMAGER will be displayed.
12. From the "Transfer" menu, select Send Text File.
13. In the "Look-in" field, enter the drive and folder where the file is located.
14. In the "Files of Type:" field, select All Files (*.*).
15. In the "Filename:" field, enter the name of the file you want to send, and click [Open].
Note
The S-records should begin transferring and, after a short delay, the IMAGER will return a (.) for
each group of records received successfully.
16. If X's are received, stop the transfer.
Note
X's indicate an error in the received record and the transfer will not be successful.
a. From the "Call" menu, select [Disconnect] then select [Call] from the "Call" menu.
b. De-energize and energize the IMAGER.
Note
You do not have to wait until the self test is complete before continuing. You may continue after
receiving +++ ATSO =1 from the IMAGER.
c. Restart the procedure at step 11.
Note
After a successful transfer, the IMAGER sends the following messages, then boots and does a
self--test after it energizes:
Reprogramming IMAGER FEEPROM
Erasing Sector XxXXXXXXXX
Writing Data to Sector XxXXXXXXXX
*** Reprogramming Operation Complete ***
+++ATSO=1
2-9-2. Installing Software using ProComm Plus
Use this procedure to install software updates on the IMAGER using ProComm Plus.
1. From the SERVICE COMPUTER, launch ProComm Plus.
2. In the "OPTIONS" pull--down menu, select System Options, and then Modem Connection.
3. Select direct connect- -Com 1 for the Current Modem/Conection.
2-28 1908110 2004 December Rev. S