Kodak DryView 8300 Service Manual page 322

SERVICE MANUAL
IMAGER Lock Up: No Longer occurs when printing write enabled RDOS formatted DISKS.
Floating Point & Integer Magnification: Now accepted by the DZO command in both decimal & hex.
Software Downloaded Checks for Correct Address: Occurs before reprogramming flash EPROMs.
Software Downloaded Checks IMAGER: Checks that the correct IMAGER software is downloaded.
Calibration Software: Rewritten to smooth D log E data then is interpolated with cubic spline.
Printed Calibration Wedge Film: Modified to have 1 inch border at top & half inch at bottom.
Intermittent System Crashing: Corrected by removing all system traps from board ISRs.
Version 4.1.1 Never released
Error Log Increments: Indicates the total number of errors over 50 and displays the last 50 errors.
Film Calibrated after Waking: The film is now calibrated when the system wakes from Energy Saver
mode instead of 24 hours after the last calibration.
Audible Alerts on Keypad: Beeps once for a successful acquisition and 3 times for an error.
Film Format Based on Zones: Defined in the DZO command(s) instead of best fit format.
SCSI Target Debug: Statements have been added and can be observed with CTRL D.
Cubic Spline Interpolation: Now used before generating the gamma table linearly.
Cubic Spline Data and 20 Cal Bands: Can now see p-value ULUT and exposure with CTRL D.
New Convolution Kernels: Now used and sum to 16384.
Version 4.1 ( Effective 7/18/97, beginning with Serial Number 1291)
SCSI Target Mode: Now operates correctly when a reset is sent from a rebooted host COMPUTER.
SCSI Code: Corrected to present test software from being compiled in production.
Film Density Drift: Reduced by super heating and "Regulating Temp" after warm up.
rd
DENSITOMETER LAMP Calibration: Now done before each film calibration and failure reported after 3
failure.
nd st
SCSI Disk Installed Menu: Displays for 2 SCSI DEVICE after exiting 1 menus if "Autoprint" is off.
SONY COLOR PRINTER Errors: Eliminated errors caused by other tasks and/or incorrectly reported.
SCSI Disk Eject Instructions: Now displayed when operator exits SCSI menu without printing.
Digital Acquisition Timeout: Now 60 seconds of no activity on the digital MODALITY line.
SCSI Color Only DISKS: Now print correctly even if no black and white images are on the DISK.
Narrow Film Calibration Bands: For previously interpreted as 2 bands, is now be visible as 1 band.
Software Continuous Improvement: Implemented to provide a more flexible baseline.
Host Control MSZ Command: Now works for IMAGER and will respond with PAS 0810 0810 0810.
1908110 2003 September Rev. Q
9-10