Configuring The Snmp Parameters - Nokia IP40 User Manual

9
Configuring and monitoring using SNMP
To enable SNMP Access:
1. Click Setup in the main menu, and click on the Management tab.
The Management window appears.
2. Click the drop-down menu against SNMP, and select one of the following:
!
!
!
!
!
If you select Internal Network, then SNMP access to the IP40 is allowed only from
computers in your internal network or LAN; if you select IP Address Range, you can specify
a range of IP addresses from where SNMP access is allowed to your IP40 and so on.

Configuring the SNMP Parameters

Once you set the SNMP access rules, you can configure the SNMP parameters from the Nokia
IP40 GUI.
To configure the SNMP parameters:
1. Define the SNMP community name.
A community name must be specified if you want to monitor your device using SNMP.
2. Click on the Advanced tab.
The SNMP Configuration window appears:
104
Internal Network
Internal Network + VPN
IP Address Range
ANY
Disabled
Nokia IP40 User Guide