Configuring The Nokia Ip40 For Oob From The Cli; Configuring The Modem Settings From The Cli; Secure Shell And Https Access Through Out Of Band Dial-In - Nokia IP40 User Manual

Configuring the Nokia IP40 for OOB from the CLI

The set interface oob command can be used for configuring the OOB parameters.
set interface oob
Similarly the show interface oob command can be used for viewing the OOB parameters.

Configuring the modem settings from the CLI

You can set the modem settings like dial mode, custom initialization string and baud rate from
the IP40 CLI.
set modem
Refer to the Nokia IP40 CLI Reference Guide for more information on using the OOB
commands.
Secure Shell and HTTPS Access through Out of Band
Dial-in
You can access the Nokia IP40 using Secure Shell (SSH) or HTTPS and configure the device.
Once you dial in to the Nokia IP40 from a modem (Refer to
IP40" on page 107 for details), you can establish a normal SSH or HTTPS session.
Refer to
HTTPS Web Access"
Note
You should allow SSH and HTTPS access on the Nokia IP40 before you establish the
sessions from OOB dial-in. Refer to
Nokia IP40 User Guide
address
destination
disable
echo-interval
enable
idle-time
max-echo-failures - Set maximum LCP echo failures
vjcompression
dialmode - Set modem dial mode
extrainit - Set custom initialization string
manufacturer - Configure modem Manufacturer
rate - Set modem baud rate
"Secure Shell" on page 95 for details on using the Secure Shell and to
on page 99 for details on using HTTPS.
Configuring the Nokia IP40 for OOB from the CLI
- Set address of oob interface
- Set destination address of oob interface
- Disable out of band management
- Set LCP echo interval
- Enable out of band management
- Set idle time
- Set IP header compression (VJ Compression)
"Configuring Virtual Servers"
"To connect a modem to the Nokia
"Enabling
on page 82 for details.
109