Firmware Upgrade In Failsafe Mode; Installing Your Product Key - Nokia IP40 User Manual

Firmware Upgrade in Failsafe Mode

When the IP40 goes to failsafe mode, you can use the following procedure for upgrading the
firmware. Refer to
page 110 for information on upgrading firmware in failsafe mode through OOB.
To upgrade the firmware using Console and LAN
1. Connect to the console. Use "admin" and "password" as the default user name and
password.
Welcome to IP40 (failsafe)
login: admin
password:
Device is running in failsafe mode. You must upgrade the device
immediately.
2. Specify the LAN IP address and Netmask when prompted.
3. The device waits for the FTP client to upload the firmware once the LAN interface is
configured.
Device is waiting for ftp client to upload the firmware.
You must close ftp session using 'quit' command after uploading
firmware.
Press Ctrl+C to Cancel.
4. FTP to the configured LAN IP address and upload the firmware.
5. The device requests your confirmation for firmware upgrade after successful firmware
upload. Press 'y' to confirm.
6. The device displays the appropriate message depending on success or failure of firmware
upgrade.

Installing Your Product Key

Your IP40 is identified by the product key that is obtained when you purchase the device. You
can purchase and upgrade to any of the other versions of the IP40.
To install a product key
1. In the Navigation Bar click Setup.
2. Click the Firmware tab.
The Firmware page appears
Nokia IP40 User Guide
"Upgrading the firmware through Out of Band Dial-in (Failsafe Mode)"
Firmware Upgrade in Failsafe Mode
on
119