IP40 Nokia QUICK START GUIDE N450915001 Rev A October 2003...
Power on Your IP40 Connect the power adapter to the power port on the rear panel of the IP40, and then plug in the power adapter to a power source. The PWR LED on the front panel will light up, indicating that the IP40 is now powered on.
The IP40 ships without a password defined. Set up the administrator password and press OK. The Setup Wizard pops up automatically. Use the wizard to configure the IP40 for Internet connection. If you wish to to use the wizard later, click Cancel.
Enter the Gateway ID and Registration Key as defined in the central management server and click Next. The services to which you have subscribed becomes available on your IP40. If your IP40 is not centrally managed, ensure that the ‘I wish to connect to a Service Center’ checkbox is not checked, and click Next.