To Reset The Ip40 To Factory Defaults Using The Reset Button - Nokia IP40 User Manual

11
Configuring Device Functions
3. Click OK.
!
!
!
!
Note
Since the network settings change, you will not be able to access the device immediately.
Release and Renew the IP address by running the Refresh IP tool located in the tools folder
on the CDROM, and then access the IP40 GUI portal.

To reset the IP40 to factory defaults using the Reset button

Restore Defaults button is inside a hole on the back panel of the IP40. To press the button, use a
large flat tipped object, such as a thick papaer clip. Pressing the Restore Defaults button for 7
seconds restores all IP40 settings back to factory defaults. The button works only after booting is
complete, and the green light must be illuminated to activate the button. The status light goes off
while defaults are being restored, and re-lights after defaults are restored and the IP40 begins to
reboot. It takes over 2 minutes to restore defaults.
122
The Please Wait screen appears.
The IP40 returns to its factory defaults.
The IP40 is restarted (the PWR LED flashes quickly).
This may take up to a minute.
The Login page re-appears.
Nokia IP40 User Guide