Configuring The Snmp Parameters - Nokia IP40 User Manual

9
Configuring and Monitoring SNMP
To enable SNMP access
1. Click Setup in the main menu, and click the Management tab.
The Management window appears.
2. Select one of the following from the SNMP drop-down menu list.
If you select Internal Network, SNMP access to the IP40 is allowed from computers in your
internal network or LAN only; if you select IP Address Range, you can specify a range of IP
addresses from which SNMP access is allowed to your IP40.

Configuring the SNMP Parameters

When you set the SNMP access rules, you can configure the SNMP parameters from the Nokia
IP40 Security Platform GUI.
To configure the SNMP parameters
1. Define the SNMP community name in the Management window. See
access"
A community name must be specified to monitor your device by using SNMP.
2. Click the Advanced tab.
The SNMP Configuration window appears.
120
Internal Network
Internal Network + VPN
IP Address Range
ANY
Disabled
on page 120
Nokia IP40 Security Platform User's Guide v1.1
"To enable SNMP