Configuring The Ip30 For Internet Connection - Nokia IP30 User Manual

2. Connect the WAN cable:
3. Connect the power adapter to the power socket, labeled PWR,
4. Plug in the AC power adapter to the wall electrical outlet.
Warning
The AC adapter is compatible with either 120 V AC or 230 V AC input power.
Verify that the wall outlet voltage is compatible with the voltage specified on
your power supply. Failure to observe this warning can result in injuries or
damage to equipment.
Figure 4 Rear Panel Connections
Configuring the IP30 for Internet
Connection
Configure the Internet connection to IP30 before you can access the
Internet through the IP30.
Nokia IP30 User Guide
Connect one end of the Ethernet cable to the WAN
port at the back of the unit.
Connect the other end of the Ethernet cable to a cable
modem, xDSL modem, or a corporate network.
at the back of the device.

Configuring the IP30 for Internet Connection

27