Configuring And Activating Interfaces; Monitoring Network Interface Cards Or Adp Modules - Nokia Check Point IP2450 Installation Manual

4
Installing and Replacing Network Interface Cards and ADP Modules

Configuring and Activating Interfaces

The Check Point IP2450 appliance automatically detects any new interfaces when either 6U
PMC carrier or ADP module is completely installed. Use Check Point Network Voyager to
configure and activate the logical and physical interfaces on the NIC or ADP module.
For information about configuring and activating ADP module interfaces, see
IP2450 Appliance ADP Services Modules."
For information about how to access Check Point Network Voyager and the related reference
materials, see

Monitoring Network Interface Cards or ADP Modules

You can assess the general operating condition of the NICs or ADP modules in your appliance
by looking at the LED status indicators on each NIC or ADP module.
The status indicators for each NIC are explained in
Network Interface Cards."
The status indicators for ADP modules are explained in
ADP Services Modules."
Use Check Point Network Voyager to access detailed port information. For information about
how to access Check Point Network Voyager, see
page 42.
You can also use the Check Point IPSO tcpdump command to examine the traffic on a specific
port.
60
"Using Check Point Network Voyager"
Check Point IP2450 Security Platform Installation Guide
on page 42.
Chapter 5, "About IP2450 Appliance
Chapter 6, "About IP2450 Appliance
"Using Check Point Network Voyager"
Chapter 6, "About
on