Using SSH Client
You first need to have an SSH client to connect to the SSH server running on IP40. Install an
SSH client if you do not have one already.
You can use the SSH client to connect to the IP40 using password authentication or public key
authentication. Refer to the user manual of the SSH client you are using for additional
information.
Configuring Advanced Secure Shell Server Options
For additional information on using the command line options, refer to CLI Reference Guide.
Configuring Server Authentication of Users
Use the following commands to configure the type of authentication the server will use to
authenticate users:
set ssh server
Use the following commands to show user authentication configurations.
show ssh server
Configuring Server Protocol Details
Use the following commands to configure SSH protocols.
set ssh server
Use the following commands to show SSH protocol configurations.
show ssh server
Nokia IP40 User Guide
password-authentication <0 / 1>
publickey-authentication <0 / 1>
password-authentication
publickey-authentication
ciphers name
keepalives <on / off>
listen-addr address
listen-addr2 address
maxconnections Number
port <1-65535>
ciphers
keepalives
listen-addr
listen-addr2
maxconnections
port
Secure Shell
97