Accessing The Nokia Ip40; Connection Methods; Configuration Methods - Nokia IP40 User Manual

4

Accessing the Nokia IP40

This chapter discusses the methods for accessing and configuring the Nokia IP40. This chapter
also provides an introduction to managing large scale deployments of the IP40 centrally using
Nokia Horizon Manager, SmartCenter Large Scale Manager and Sofaware Security
Management Portal.
The main topics for this chapter include:

"Connection Methods"

!

"Configuration Methods"

!
"Connecting the Nokia IP40 to a computer by Using the Console Port"
!
"Using Telnet to Connect to the Nokia IP40"
!
! "Enabling and Disabling Telnet Access to the Nokia IP40"
! "Accessing the Nokia IP40 using HTTP and HTTPS"
! "Managing large scale deployments of the Nokia IP40"
Connection Methods
You can connect to your IP40 locally through LAN, WAN, DMZ or Console ports for Inband
management. You can also connect from a remote location using modem dial-in for Out of Band
Management (OOB).
For information on using OOB to configure your device, refer to
through Out of Band Management"
Typically your device's WAN port is connected to your Internet Service Provider (ISP), while
the LAN port is connected to your computer, or to a hub, in case you are using IP40 between
your computer network and the outside world. You can connect your computer to the console
port of your IP40 to manage the device using CLI.
Configuration Methods
The Nokia IP40 supports the following configuration methods:
Command-line interface using console, Telnet, Secure Shell (SSH).
!
! Web user interface using http and https.
Nokia IP40 User Guide
on page 49
on page 44
on page 51
on page 107.
on page 50
on page 53
on page 53
on page 53
"Configuring the Nokia IP40
49