Setting Up Ip40 Tele 8; Setting Up Check Point Ng Ai; Site-To-Site Vpns; Ip40 Satellite X In Nat And No-Nat Modes - Nokia IP40 User Manual

IP40 Tele 8 uses only a manual mode VPN connection. To select the VPN gateway to which you
want to establish a VPN connection, go to http://my.vpn.

Setting up IP40 Tele 8

To configure a VPN Tunnel between an IP40 Tele 8 and Check Point FP3, on IP40 Tele 8 (VPN
client) add a VPN site.

Setting up Check Point NG AI

Configure a Safe@gateway dynamic object on the Check Point SmartBoard.
To set up Check Point NG AI
1. Create a Safe@gateway as a dynamic object.
2. Create a user and add the user to the VPN users group.
3. Create a remote access VPN community.
Include NG AI firewall object in the participating gateway.
Include the Users group in the participating users.
4. In the policy editor, create a rule with
Source User - any
Destination - any
Via - remote access community
Target - NG AI firewall object
Note
You can also use Check Point FP3 in place of NG AI

Site-to-Site VPNs

IP40 Satellite X in NAT and No-NAT Modes

VPN configuration allows you to choose how your VPN should function. Use of NAT and No-
NAT modes offers great flexibility.
No-NAT is the default mode of operation, in which the protected networks at each site are known
and are predefined.
NAT mode allows you to define VPNs at peer gateway sites without knowing the protected
network behind the IP40 devices.
Nokia IP40 User Guide
Site-to-Site VPNs
145