Derbi GPR 125 Racing Workshop Manual page 76

4. Fit:
- Friction disks (1).
- Separators (2).
N.B.
- FIT THE DISKS AND SEPARATORS ALTERNATELY INTO THE
CLUTCH ASSEMBLY, STARTING WITH A FRICTION DISK
AND
ENDING WITH A FRICTION DISK AS WELL.
- LUBRICATE ALL THE DISKS AND SEPARATORS WITH ENGI-
NE OIL BEFORE FITTING.
- BE SURE TO FIT EACH SEPARATOR WITH ITS PROJECTIONS
TURNED AT 90º TO THE PREVIOUS ONE. CONTINUE WITH
THIS PROCEDURE IN A CLOCKWISE DIRECTION UNTIL ALL
THE SEPARATORS HAVE BEEN INSTALLED.
5. Fit:
- Activating rod.
- Ball.
6. Fit:
- Pressure plate (1).
- Compression springs (2).
- Bolts (3).
Bolts (clutch spring):
0,6 Kgf.m (6 N.m)
N.B.
TIGHTEN THE SPRING BOLTS GRADUALLY AND IN A DIA-
GONAL FASHION.
7. Check:
- Position of the activating plate.
Push the lever assembly in the direction of the arrow and
ensure that the alignment marks line up.
75