Installing The Clutch Bell Housing; Fitting The Clutch - Derbi GPR 125 Racing Workshop Manual

I I
NSTALLING THE CLUTCH BELL HOUSING NSTALLING THE CLUTCH BELL HOUSING
1. Fit:
- Balancing gear
- Primary gear
- Clutch bell housing
N.B.
TAKE CARE TO FIT THE BALANCING GEAR AND THE PRI-
MARY GEAR WITH THE CENTRING MARKS LINED UP.
F F
ITTING THE CLUTCH ITTING THE CLUTCH
1. Fit:
- Clutch bell casing (1).
- Pressure washer (2).
- Clutch housing (3).
- Tab washer (4).
- Clutch housing nut (5).
2. Tighten:
- Clutch housing nut.
N.B.
TIGHTEN THE CLUTCH HOUSING NUT WHILE HOLDING
THE HOUSING WITH THE UNIVERSAL CLUTCH HOLDER .
Clutch holder:
00M12501260
Clutch housing nut:
70 N.m (7.0 kgf.m)
3. Fold:
- Edge of tab washer (1).
(upwards onto a flat side of the nut)
74