Download  Print this page

Advertisement

Table of Contents
2. Extract:
- Magneto flywheel (1).
- Pin.
N.B.
EXTRACT THE MAGNETO FLYWHEEL USING THE ROTOR
EXTRACTOR (2).
CENTRE THE ROTOR EXTRACTOR ON THE MAGNETO
FLYWHEEL. ENSURE THAT THE GAP BETWEEN THE EX-
TRACTOR AND THE FLYWHEEL IS THE SAME AT ALL PO-
INTS AFTER FITTING THE SECURING BOLTS. IF NECESSARY,
LOOSEN ONE OF THE BOLTS TO ADJUST THE EXTRACTOR
POSITION.
ATTENTION
COVER THE END OF THE CRANKSHAFT WITH THE SPAN-
NER TO PREVENT DAMAGE.
Magneto flywheel extractor:
00M12501259
3. Extract:
- Plate (1).
- Starter gear (2).
4. Extract:
- Needle bearings (1).
- Support shaft (2).
5. Extract:
- Nut
- Washer
- Drag pinion
C
C
LUTCH
LUTCH
N.B.
THE CLUTCH ASSEMBLY CANNOT BE REMOVED WITH THE
ENGINE MOUNTED ON THE FRAME. FOR THIS, SEE "RE-
MOVING THE ENGINE FROM THE CHASSIS".
1. Extract:
- Right hand crankcase cover.
N.B.
LOOSEN THE BOLTS FOLLOWING A DIAGONAL SEQUEN-
CE. DRAIN THE OIL FROM THE CLUTCH UNIT.
50

Advertisement

Table of Contents

   Also See for Derbi GPR 125 Racing

This manual is also suitable for:

Gpr 125 racing

Comments to this Manuals

Symbols: 0
Latest comments: