Nas Cables Installation - IBM 300 Service Manual

b. Plug one T connector (PN 80G0638) into the alarm and power control
(APC) card connector 4.
c. Route and plug the cable B (PN 10K8668) from the connector 6 of the
APC card into the Ethernet card connector 5 .
d. Route and plug in the cable C (PN 80G0637) from the T connector
located on connector 4 of the APC card to the tailgate connector J2.
e. Plug the mouse cable D into the NAS connector 3 .
f. Plug the keyboard cable E into the NAS connector 2 .
g. Plug the power cable F into the NAS connector 6 of the NAS.
4. ____ Plug the power cords F and G into correctly grounded electrical
outlets.
Figure 1-2. NAS Cables Installation
Installing the NAS and Its Modem
Chapter 1. Installing and Configuring the NAS and Its Modem
1-3