Location in the rack ....................... 18 Package contents: ......................20 Contents: 00RR851, duct kit ..................20 Contents: 3454-CAC spine switch ................21 Installation procedure ....................21 Installing 100G spine switches in a rack ..............21 Before you begin ..................... 21 About this task ......................
Page 6
Electrical voltage and current from power, telephone, and communication cables are hazardous. To avoid a shock hazard: • If IBM supplied the power cord(s), connect power to this unit only with the IBM provided power cord. Do not use the IBM provided power cord for any other product.
Page 8
Use of the controls or adjustments or performance of procedures other than those specified herein might result in hazardous radiation exposure. (C026) IBM® servers can use I/O cards or features that are fiber-optic based and that utilize lasers or LEDs. Laser compliance IBM servers may be installed inside or outside of an IT equipment rack.
Publications The following IBM documentation is available on the Safety and Regulatory CD included with your Cloud Pak for Data System rack & components: **** General Information Guides **** • Rack Safety Information • IBM Enterprise Slim Rack Safety Instructions •...
Cloud Pak for Data System 100G spine switch description The IBM Cloud Pak for Data Systems spine switch is a 1U, rack mountable, data center switch that delivers up to 32 ports at 100 GbE. The switch comes as a pretested building block loaded with software.
All component installation documents are available on the Safety and Regulatory CD that comes with your Cloud Pak for Data System components. 3454-CAC, Cloud Pak for Data System Spine Switch (100G switch) [see Notes 1, 2] Table 1 Amperage...
Location in the rack The base IBM Cloud Pak for Data System consists of four main components (1G switch, 25G switch, two compute chassis) that are designed to be integrated in the same rack with PDUs. The spine switch typically installs in the third rack as shown in figure 2 below.
Package contents: If anything is damaged or missing, contact your IBM representative. Contents: 00RR851, duct kit * Choose one nut type, according to the rack that you are installing the system in (square or round rail holes). Duct kit: 00RR851, Customized for IBM racks with 720mm depth...
Page 24
7. Plug in the required cables, and route them through one of the designated windows in the brackets, as shown in Figure 7. (This step will be done by the IBM installers. If the installers are not available, continue to the next step, duct install)
Page 26
DO NOT BLOCK ANY INLET OR EXHAUST DUCTS, VENTS OR PORTS KEEP ALL POWER CORDS, SIGNAL CABLES AND TRANSCEIVERS WITH THE INSTALLED CHASSIS FOR USE BY IBM INSTALLERS. DO NOT POWER-ON THIS CHASSIS. POWER ON WILL BE DONE BY YOUR IBM INSTALLATION TEAM.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Proper cables and connectors are available from IBM-authorized dealers. IBM is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment.
Page 28
EU-Mitgliedsstaatenund hält die Grenzwerte der EN 55032 Klasse A ein. Um dieses sicherzustellen, sind die Geräte wie in den Handbüchern beschrieben zu installieren und zu betreiben. Des Weiteren dürfen auch nur von der IBM empfohlene Kabel angeschlossen werden. IBM übernimmt keine Verantwortung für die Einhaltung der Schutzanforderungen, wenn das Produkt ohne Zustimmung von IBM verändert bzw.
Page 29
Erweiterungskomponenten von Fremdherstellern ohne Empfehlung von IBM gesteckt/eingebaut werden. EN 55032 Klasse A Geräte müssen mit folgendem Warnhinweis versehen werden: "Warnung: Dieses ist eine Einrichtung der Klasse A. Diese Einrichtung kann im Wohnbereich Funk-Störungen verursachen; in diesem Fall kann vom Betreiber verlangt werden, angemessene Maßnahmen zu ergreifen und dafür aufzukommen."...
Consult your local IBM representative for information on the products and services currently available in your area. Any reference to an IBM product, program, or service is not intended to state or imply that only that IBM product, program, or service may be used. Any functionally equivalent product, program, or service that does not infringe any IBM intellectual property right may be used instead.
Page 34
Web sites. The materials at those Web sites are not part of the materials for this IBM product and use of those Web sites is at your own risk. IBM may use or distribute any of the information you supply in any way it believes appropriate without incurring any obligation to you.
You may copy, modify, and distribute these sample programs in any form without payment to IBM, for the purposes of developing, using, marketing or distributing application programs conforming to the application programming interface for the operating platform for which the sample programs are written.
IBM, the IBM logo, ibm.com® and Netezza® are trademarks or registered trademarks of International Business Machines Corporation in the United States, other countries, or both. If these and other IBM trademarked terms are marked on their first occurrence in this information with a trademark symbol (® or ™), these symbols indicate U.S.
IBM business partner, or your authorized remarketer. When you send comments to IBM, you grant IBM a nonexclusive right to use or distribute your comments in any way it believes appropriate without incurring any obligation to you. IBM or any other organizations will only use the personal information that you supply to contact you about the issues that you state on this form.