Download Print this page

Display Connection To The Nas - IBM 300 Service Manual

Nways switch administration station
Hide thumbs

Advertisement

4. At the rear of the rack, connect the display signal cable L to the NAS
Figure 6-15. Display Connection to the NAS
5. Connect the display power cable to the electrical outlet.
6. Switch on the display using the power ON/OFF switch located on the front panel
7. Check that your display is working.
8. Go to "Leaving Procedure" on page 5-30.
6-12
2220 Setup and Service Guide
connector (see Figure 6-15).
(see Figure 6-9 on page 6-8).
L

Advertisement

loading

  Related Manuals for IBM 300

This manual is also suitable for:

5005012220 nways 3002220 nways 5002220 nways 5016563