Figure 6-7. Display Installation on Top of 29U Rack
3. Route the display power and signal cables through the top opening.
4. Reinstall the top cover B (see Figure 6-4 on page 6-3). Be sure that the signal
5. At the rear of the Nways Switch administration station, connect the display
2220 Setup and Service Guide
c. Put the display in place (near the front of the machine).
d. Once the display is in place, secure it by tightening the screws F .
and power display cables are correctly routed in the top aperture C . Secure
the top cover with the screws A previously removed.
signal cable L (see Figure 6-8 on page 6-7).