Download Print this page

Connecting The Nas To The Display And Keyboard In The 37U Rack; Display Assembly Installation In A 37U Rack - IBM 300 Service Manual

Nways switch administration station
Hide thumbs


Installing the NAS and Its Modem
Figure 1-17. Display Assembly Installation in a 37U Rack
7. ____ Go to "Connecting the NAS to the Display and Keyboard in the 37U

Connecting the NAS to the Display and Keyboard in the 37U Rack

1. ____ See Figure 1-18 on page 1-15 to route and locate the cables. See
2. ____ Plug the power cords F and G into correctly grounded (earthed)
3. ____ Secure keyboard cable E and mouse cable D to the rack using tie
2220 Setup and Service Guide
Figure 1-19 on page 1-15 to locate the connectors at the rear side of the NAS.
Attach the cables as follows:
a. ____ Connect the display signal cable A to the NAS connector 1 .
b. ____ Plug one T connector (PN 80G0638) into the APC connector 4.
c. ____ Route and plug cable B (PN 10K8667) from the connector 6 of the
APC card into the Ethernet card connector 5 .
d. ____ Route and plug cable C (PN 80G0637) from the T connector
located on connector 4 of the APC card into the tailgate connector J2.
e. ____ Plug the mouse cable D into NAS connector 3 .
f. ____ Plug the keyboard cable E into NAS connector 2 .
g. ____ Plug the power cable F into NAS connector 6 .
electrical outlets.
clamps H (PN 1159519).



  Related Manuals for IBM 300

This manual is also suitable for:

5005012220 nways 3002220 nways 5002220 nways 5016563