Drain Rod Switch - Henny Penny Evolution Elite EEE-153 Technical Manual

6-20. OIL LEVEL PROBES
(Continued)
6-21. DRAIN ROD
MICROSWITCH
409
5. Connect new temperature probe to the connector and
fasten connector onto control panel.
6. Replace control panel and reconnect power to vat.
7. Fill vat by pressing and holding
*FILTER* *MENU* shows in the display. Then once
"1.EXPRESS FILTER" shows in the display, press
times until "5.FILL FROM PAN" shows in the display.
Press  button and "PUMP" "EXIT" shows in the
display. Press  button again, and oil fi lls vat. Once vat is
full, press X twice to return to normal operation.
This component prevents the elements from heating while the
drain is open by disrupting the power to the heat contactor.
Checkout:
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Remove control panel and hinge it down.
2. Refering to the decal on the rear of the control panel, locate
P9 connector (left vat-split vat) or P10 connector (full or right
vat).
3. Check for normally open circuit between the 2 appropriate
pins. If the circuit shows closed, continue with the
replacement instructions below.
Replacement:
1. Remove right or left side panel, depending upon what side
the faulty switch is on.
2. Pull connector from behind control panel area.
3. Using Phillip's-head screwdriver and a 5/16" socket,
remove the nut and screw securing the switch and remove
switch from unit.
4. Remove wires from switch and place on new switch,
placing them on the normally open and common terminals.
5. Install new switch in reverse order.
Model EEE-153, 154
button until
4
6-26