Henny Penny Evolution Elite EEE-153 Technical Manual page 11

1-4. ERROR CODES
DISPLAY
"E-4" Control board
overheating
"E-5" Oil
overheating
"E-6A" Temperature
probe open
"E-6B" Temperature
probe shorted
"E-10" High limit
"E-18-A" Left level sensor open
"E-18-B" Right level sensor open if display still indicates a failed sensor, have the connectors
"E-18-C" Both level sensors open checked at the control board; have sensor checked & replace if
"E-21" Slow heat recovery
409
In the event of a control system failure, the digital display
shows an error message. The message codes are shown in the
DISPLAY column below. A constant tone is heard when an er-
ror code is displayed, and to silence this tone, press any button.
CAUSE
Turn switch to OFF position, then turn switch back to ON;
if display shows "E-4", the control board is getting too hot;
check the louvers on each side of the unit for obstructions
Turn switch to OFF position, then turn switch back to ON;
if display shows "E-5", the heating circuits and temperature
probe should be checked
Turn switch to OFF position, then turn switch back to ON;
if display shows "E-6A", the temperature probe should be
checked
Turn switch to OFF position, then turn switch back to ON;
if display shows "E-6B", the temperature probe should be
checked
Reset the high limit by using a small screwdriver or Allen
wrench gently pushing it into the hole in the heating element
hinge; if high limit does not reset, high limit must be replaced
Turn switch to OFF position, then turn switch back to ON;
necessory
Have a certifi ed service technician check the fryer for correct
voltage to the unit; have the contactors and heating element
checked; have unit checked for loose or burnt wires
CORRECTION
Model EEE-153, 154
1-7