Henny Penny Evolution Elite EEE-153 Technical Manual page 36

5-5. TECH MODE (Continued)
5-13
1. Press and hold the
2", followed by, "SP PROG" and "ENTER CODE" show in
the display.
2. Press the button 4 times and "TECH" and "ENTER
CODE" fl ash in the left display.
3. Enter code 1, 1, 2, 2, 1, 1, 2, 2 (fi rst 2 product buttons).
4. "T-1 SOFTWARE" fl ashes in the left display and
"EV-ELITE" shows in the right display. Use the
buttons to select the steps.
If a bad code is entered, a tone sounds and "BAD CODE"
shows on the display. Wait a few seconds, the controls
revert back to the cook mode, and repeat the above steps.
Press and hold
operation.
T-1 - SOFTWARE
• Press to view HP Part No. of eprom
• Press to view software ID
• Press to view software version
T-2 - FRYER TYPE - GAS or ELEC
T-3 - PUSH-BUTTON TEST
Press any of the control buttons to test operation. You should hear a
beep, and the LED should light and/or a display.
T-4 - ALL ON DISPLAY TEST
Press any of the product buttons and all the LEDs and display
segments should light.
T-5 - SEGMENTS TEST
Press button to view the different segments of the display
characters.
T-6 - DIGITS TEST
Press button to view all segments of each digit across the
displays.
Model EEE-153, 154
button for 5 seconds until "LEVEL
button at anytime to return to normal
and
409