Henny Penny Evolution Elite EEE-153 Technical Manual page 9

Problem
Oil foaming or boiling over vat
Oil will not drain from vat
Oil leaking
through drain valve
Vat is under-fi lled
Bubbles in oil during
entire fi ltering process
409
Cause
OIL LEVEL SECTION
• Water in oil
• Improper or bad oil
• Improper fi ltering
• Bottom of vat full of crumbs
• Improper rinsing after
cleaning the fryer
• Drain valve clogged with
crumbs
• Oil channel clogged
• Obstruction in drain
• Faulty drain valve
• JIB is low or empty
• JIB oil line is clogged or
collapsed
• Filter pan needs cleaned
• Filter pan not completely
engaged
• Filter pan clogged
• Damaged o-ring on fi lter
line tube on fryer
Model EEE-153, 154
Correction
• At end of a Cook Cycle,drain vat
and clean vat; add fresh oil
• Use recommended oil
• Refer to the procedure
covering fi ltering the oil
• Filter oil
• Rinse the vat thoroughly to remove
any cleaning agent in the vat
• Open valve, force cleaning brush
through drain
• Access the clean-out plug on the
sides of the unit (see Oil Channel
Clean-out Section)
• Remove obstruction
• Replace drain valve
• Fill the JIB
• Check JIB line
• Clean fi lter pan and change pad
• Make sure fi lter pan return line is
pushed completely into the receiver
on the fryer
• Clean pan and change pad
• Change O-ring
1-5