Installing A Hard Disk Drive In The Slot Load Optical Bay - HP Z800 Workstation Maintenance And Service Manual

Installing a hard disk drive in the slot load optical bay

1.
2.
3.
4.
118 Chapter 5 Replacing components
Downloaded from www.Manualslib.com
With power off and the workstation open, remove the expansion card support and any card cables
that might interfere with slot load assembly installation.
Remove the slot load optical bay assembly. (See
on page 102 for details.)
Place the hard drive in the slot load carrier at an angle and push it into the carrier as shown in the
following figure.
Figure 5-52 Positioning the drive in the carrier
Rotate the hard drive flat, and adjust its position so the drive holes align with the carrier holes.
Fasten the drive in the carrier with the four Torx slotted screws supplied with the disk drive as shown
in the following figure.
Figure 5-53 Fasten the hard drive in the carrier
manuals search engine
Removing the slot load optical disk drive
ENWW