5.
6.
112 Chapter 5 Replacing components
Downloaded from
www.Manualslib.com
Set the hard drive in the carrier at an angle. Carefully separate the lower hard drive carrier rails
, and then lower the drive between them as shown in the following figure.
Align the carrier pins with the drive mounting holes and release the rails to secure the lower-end
of the drive in place.
Figure 5-43
Installing the drive in the carrier
Carefully separate the upper hard drive carrier rails
shown above.
Align the carrier pins with the drive mounting holes and release the rails to secure the upper-end
of drive in place.
manuals search engine
, and then rotate the drive upright
2
, as
ENWW