Expansion Card Guide/Front Fan Holder; Removing The Expansion Card Guide/Front Fan Holder - HP Z800 Workstation Maintenance And Service Manual

4.
5.

Expansion card guide/front fan holder

This section describes how to remove and install the expansion card guide/front fan holder.

Removing the expansion card guide/front fan holder

1.
2.
3.
4.
5.
ENWW
Downloaded from www.Manualslib.com
Connect one end of the data cable to the hard drive as shown in the following figure.
Figure 5-71 Connecting the data cables to the hard drives
Connect the opposite end of the data cable to the system board. Start with the lowest numbered
port connector available on the system board.
NOTE: Repeat steps 2–4 for the second hard drive.
Disconnect power from the workstation (see
Remove the side access panel (see
Remove the expansion card support (see
Remove the airflow guide (see
Remove expansion cards that are located in the card guide.
manuals search engine
Predisassembly procedures on page
Removing the side access panel on page
Removing the expansion card support on page
Removing the airflow guide on page
Removing and installing components 129
76).
78).
80).
79).