Installing The Power Switch Cable Assembly; Optical Bay Filler Tray; Removing A Filler Tray - HP Z800 Workstation Maintenance And Service Manual

10.
11.

Installing the power switch cable assembly

To replace the power switch cable assembly, reverse the removal steps.

Optical bay filler tray

If an optical bay slot is left empty, a filler tray must be placed in the slot to ensure proper electromagnetic
interference (EMI) protection and cooling air efficiency.
This section describes how to remove and install a filler tray.

Removing a filler tray

1.
2.
3.
94 Chapter 5 Replacing components
Downloaded from www.Manualslib.com
Disconnect the power switch cable assembly cable from the system board as shown in the following
figure.
Figure 5-21 Disconnecting the power switch cable assembly cable
Guide the power switch cable assembly and cable out of the chassis.
Disconnect power from the workstation (see
Remove the side access panel (see
Remove the airflow guide (see
manuals search engine
Predisassembly procedures on page
Removing the side access panel on page
Removing the airflow guide on page
76).
78).
79).
ENWW