Right side panel
This section describes how to remove and install the right side panel.
Removing the right side panel
NOTE:
1.
2.
Installing the right side panel
To install the panel, slide it into position on the workstation, and then fasten it with two T-15 Torx screws.
Power supply
This section describes how to remove and install a power supply.
Removing the power supply
1.
2.
ENWW
Downloaded from
www.Manualslib.com
Use this procedure to access the backplane wiring.
Disconnect power from the workstation (see
Remove the two T-15 Torx screws
the following figure until it stops, and then lift off the chassis
Figure 5-10
Removing the right side panel
Disconnect power from the workstation (see
Remove the side access panel (see
manuals search engine
Predisassembly procedures on page
, and then slide the right side panel in the direction shown in
.
2
Predisassembly procedures on page
Removing the side access panel on page
Removing and installing components
76).
76).
78).
83