Installing The Expansion Card Guide/Front Fan Holder - HP Z800 Workstation Maintenance And Service Manual

Installing the expansion card guide/front fan holder

1.
2.
3.
4.
5.
132 Chapter 5 Replacing components
Downloaded from www.Manualslib.com
Ensure that the fan holder includes the desired cooling fans (see
fan on page 135).
With power off to the workstation and the chassis open, place the expansion card guide/front fan
holder assembly in the chassis. Place the tabs at the bottom of the assembly into the slots in the
chassis as shown in the following figure
NOTE: When positioning the expansion card guide/front fan holder into the chassis, make sure
there are no cables between the fans and the chassis mounting wall. All workstation cables should
be located under the card guide.
TIP: To engage the hooks, you might have to press down firmly on the card guide/fan holder to
overcome cable resistance.
Rotate the assembly up until it snaps into place
Connect the cooling fan power cables to the system board (see
fan on page 135).
Reinstall all removed components and reconnect any cables that have been disconnected.
manuals search engine
Installing a second front system
.
2
Installing a second front system
ENWW