HP Z800 Workstation Maintenance And Service Manual page 192

10.
11.
180 Chapter 5 Replacing components
Downloaded from www.Manualslib.com
b. Place the graphics cables in the hard drive bays.
Place the CPU, memory power, and rear system fan cables over the chassis edge.
TIP: Use the CPU and memory power cables to hold up the shorter rear system fan cable.
The following figure presents an example of these steps.
Slide the system board forward as shown in the following figure
Figure 5-126 Removing the system board
Using the CPU heatsinks as handles, lift the system board straight up and then tilt the board to
remove it from the chassis
NOTE: If desired, remove system board components such as the CPU heatsinks and the CPUs.
manuals search engine
. Do not damage the cables and rear panel connectors.
2
.
ENWW