Optional Components - BONFIGLIOLI Active ACT 201-05 Brief Manual

5.7
Thanks to the modular hardware components, the frequency inverters can be
integrated in the automation concept easily. The standard and optional modules are
recognized during the initialization, and the controller functionality is adjusted
automatically. For the information required for installation and handling of the
optional modules, refer to the corresponding documentation.
Danger!
•
•
Attention! If two optional components with CAN-Protocol controller are installed,
06/05
06/05

Optional Components

The hardware modules at slots B and C may only be assembled and
disassembled after the frequency inverter has been disconnected safely
from power supply. Wait for some minutes until the DC link capacitors
have discharged before starting the work.
The unit may only be connected with the power supply switched off.
Make sure that the frequency inverter is discharged.
A
Connection of the optional control unit KP500 or an interface
adapter KP232.
B
A
Plug-in section for connection to various communication
protocols:
CM-232: RS232 interface
CM-485: RS485 interface
CM-PDP: Profibus-DP interface
CM-CAN: CANopen interface
B
C
Slot for customer-specific adaptation of the control inputs
and outputs to various applications:
C
EM-ENC: extended speed sensor evaluation
EM-RES: resolver evaluation
EM-IO: analog and digital inputs and outputs
EM-SYS: system bus
the system bus interface in the EM extension module is deactivated!
Hardware modules
Control Unit KP500
Communication module CM
Extension module EM
(system bus in combination with CM-CAN communi-
cation module upon request)
33
33