Actual Speed Source; Evaluation Mode; Frequency And Percentage Reference Channel; Actual Value Display - BONFIGLIOLI Vectron Manual

6.4.2
Switch-over is effected via
value signal for the speed controller, speed sensor 2 must be selected as the source In
the basic setting, speed sensor 1 is used as the actual value source.
6.4.3
If a synchronous motor which is not from BONFIGLIOLI should be connected to the
resolver input it can be necessary to change the sign of the sinus track. This can be set
via parameter
6.5
The varied functions for the specification of the reference values are connected in the
various configurations by the frequency or percentage reference channel. The
ence frequency source
additive connection of the available reference sources as a function of the installed
hardware.
14 -
24 -
102 to 124
Additional to the operation modes listed, those stated in the operating instructions of
the frequency inverter in the chapter "Frequency reference channel", and in the chap-
ter "Percentage reference channel" also apply.
6.6
The actual value of speed sensor 2 can be read via the parameters
sensor 2
The analog input signal on analog input EM-S1INA is displayed via the actual value
parameter
10/07
10/07

Actual speed source

Operation mode
1 - Speed sensor 1
2 - Speed sensor 2

Evaluation mode

Evaluation Mode
Evaluation Mode
492
0 - Bonfiglioli
1 - inverted

Frequency and percentage reference channel

475, and the
Operation mode
2 - EM-S1INA, absolute value Reference source is the analog input EM-S1INA
MFI1A + EM-S1INA, abso-
4 -
lute value
MFI1A + EM-S1INA + FF,
absolute value
MFI1A + EM-S1INA + MP,
absolute value

Actual value display

Speed speed sensor 2
219 and ,
Analog input EM
EM-RES-03
Actual Speed Source
766. If the resolver delivers the actual
The actual speed source is speed sensor 1 of the
basic device (factory setting).
The actual speed source is speed sensor 2 of the EM-
RES-03 expansion module.
492.
Factory setting. For Bonfiglioli synchronous motors.
The sign of the sinus track is changed.
Reference percentage source
Reference sources are the multifunctional input
MFI1A and the analog input EM-S1INA
Reference sources are the multifunctional input
MFI1A, analog input EM-S1INA and fixed frequency
FF
Reference sources are the multifunctional input
MFI1A, analog input EM-S1INA and the motor po-
tentiometer function MP
Operation modes with signs (+/-)
220.
S1INA
-
253.
EM-RES-03
Function
Function
476 determine the
Function
Frequency speed
Refer-
65
65