12 July '86
24. Pre-cleaning Corona Wire Replacement
1.
Remove the front and rear endblock covers [A, B]. (Be careful not to
break off the side hooks.)
2.
Unhook the old wire [C] from the tension spring [D] and remove.
3.
Clean the front and rear endblocks and the corona casing.
4.
Hook the small eyelet [E] of a new wire to the tension spring.
5.
Hook the large eyelet [F] of the new wire to the anchor post on the
front endblock cover, then set it on the front endblock. (Ensure that
the wire is in the positioning grooves.)
6.
Reassemble.
3-38