Ricoh FT7060 Field Service Manual page 16

5. Open the top unit, then remove the fusing knob [A] (1 screw: reverse
thread), cover [B] (3 screws), and the oil bottle [C]. Remove the clamp
[D] (2 screws) which secures the fusing unit and the duplex tray.
6. Turn the duplex tray handle [E] to the horizontal position, pull out the
duplex tray, and remove the two strips of tape [F] securing
unit covers. Open the duplex unit covers and carefully remove the strip
of tape securing the bottom plate. Then reset the duplex unit.
7. Unscrew the oil bottle cap [G], and fill the oil bottle with silicone oil.
Do not overfill the bottle. Reinstall the cap. Confirm that oil is supplied
to the oil sump [H] by pressing the oil supply lever [I] against the sleeve
of the oil pump several times.
8. Rotate the pressure cam shaft [J] counterclockwise until it locks (about
90°) to apply the pressure between the hot roller and the pressure
roller.
1-7
12 July '86
the duplex