Ricoh FT7060 Field Service Manual page 166

- Reassembly -
1. Place the second pick-up roller drive gear [A] on the rear plate, and
insert the second pick-up roller [B] from the bottom.
gear [C].
2. Install the one-turn disk [D]. Align the flat surface of the second pick-
up roller and the notch in the one-turn disk [E], so that they face
upwards.
Next, secure the one-turn disk and the second pick-up roller
drive gear (1 pin each).
3. Secure the front end of the second pick-up roller (1 bushing, 1 E-ring).
4. Lift the rear of the feed-in unit, and open the pressure unit. Place the
first pick-up roller [F] through the entrance mylar pressure cam [G].
5. Align the flat surface of the first pick-up roller and the lobe [H] of the
entrance mylar pressure cam. Then, secure the entrance mylar pressure
cam (1 pin, 1 E-ring).
6. Install the first pick-up roller drive gear and the cam.
7. Confirm that the flat surface of the pick-up rollers [I] and the low
section of the cam [J] are facing upwards.
the first pick-up roller drive gear (1 pin each).
8. Secure the front end of the first pick-up roller (1 bushing, 1 E-ring).
9. Reassemble.
CAUTION: - When reinstalling the tensioner, ensure that the tensioner is above
- When securing the one-turn sensor, do not overtighten the screw.
the cam.
Then, secure the cam and
5-9
12 July '86
Install the idle