12 July '86
6. Charge Cleaner Drive Wire Replacement
1. Remove the corona wires. (Refer to "Charge Corona Wire Replace-
ment".)
2. Remove the drive wire tension springs [A] and the old drive wire [B].
3. Wrap the new wire around the drive pulley two and one-half times [C].
4. Fit the drive ring [D] over the post of the wire cleaner.
5. Slip the wire over the idle pulley [E].
6. Route the drive wire as shown [F].
7. Make sure that the corona wires are between the cleaner pads.
8. Reassemble.
9. Check the wire cleaner movement using SP 5-3.
3-6