Table of Contents
Advertisement
5.
Front Wire Replacement
a.
Insert the red (upper tray)/black (lower tray) bead [A] of a new wire
into the slot of the drive pulley [B] and wrap the wire around the
drive pulley twice counterclockwise.
b.
String the wire over all pulleys except, the tension pulley [C], wrap-
ping the wire around the friction roller drive pulley [D] 5 times
counterclockwise.
c.
Wrap the other end of the wire around the drive pulley 2.5 times
counterclockwise and insert the bead into the slot of the drive pul-
ley.
d.
Insert the two support beads [E] into the slots of the lift rods [F].
e.
String the wire over the tension pulley.
6.
Reinstall the friction roller drive gear assembly [G] and the wire
tensioner spring.
7.
Confirm that the wires are not crossed and that the bottom plate moves
down by itself after being lifted manually.
8.
Reinstall the tray motor.
9.
Tighten the wire tensioners
10.
Confirm tray operation.
(1 screw each, front and rear).
3-65
12 July '86
Advertisement
Chapters
Table of Contents
