Ricoh FT7060 Field Service Manual page 174

1. Remove the DF front cover [A] (2 screws) and the DF rear cover [B] (3
screws).
2. Remove the copier upper rear cover (2 screws).
3. Lower the DF main board assembly [C] (2 screws) and disconnect the
two fiber optic cables [D].
4. Remove the feed-in unit ground wire [E] (1 screw).
CAUTION: In the next step, do not damage the fiber optic cables.
5. Remove the feed-in unit [F] (3 screws and 3 connectors).
6. Disconnect the transport unit ground wire [G] (1 screw).
7. Remove the exposure glass.
Section 3.) (This makes it easier to untangle the connectors.)
Remove the transport unit [H] (3 screws and 2 connectors).
8.
(Refer to "Exposure Glass Removal" in
5-17
12 July '86