Ricoh FT7060 Field Service Manual page 208

4. Rear Wire Replacement
a. Remove the old wire.
b.
Insert the blue end bead [A] of the new wire into the slot of the
drive pulley and wrap the wire twice around the drive pulley
(counterclockwise).
c.
String the wire over all the pulleys, except the idle pulley [B], as
shown.
d. Wrap the other end of the wire around the drive pulley 2.5 times
counterclockwise and insert the bead into the drive pulley slot as
shown.
e. Insert the support beads into the slots of the lift rods.
f. Now, string the wire over the idle pulley.
7-13
12 July '86