Ricoh FT7060 Field Service Manual page 17

12 July '86
9. Reinstall the fusing unit cover [A] and the fusing knob. Confirm that the
tab [B] on the inside of the cover lifts up the oil sump stopper. If it
does not, oil will overflow from the sump. Close the top unit.
10. Remove the two optics studs [C] as follows:
Raise the DF transport unit [D].
a)
b)
Remove the front cover [E] of the original feed unit (2 screws).
c) Remove the front top cover [F] (3 screws).
d) Loosen the two screws of the rear scale [G], and remove the glass
fixing plate [H] (1 screw).
e)
Remove the exposure glass [I].
f) Remove the two optics studs securing the lens housing and the first
scanner.
Reassemble.
g)
11. Install the original tray [J] (2 screws: M4 x 8 mm).
1-8