Ricoh FT7060 Field Service Manual page 100

ADJUSTMENT STANDARD: 2.0 mm
- Adjustment -
If the inverter roller clutch hub [A] or clutch shaft [B] has
perform the following adjustment:
8. Loosen the two Allen screws fixing the clutch hub and the clutch
shaft.
9.
Insert a 0.2 mm thickness gauge [C] at the position shown. While hold-
ing the clutch assembly against the gauge, rotate the clutch drive gear
clockwise until stopper [D] of the clutch sleeve contacts the clutch
solenoid actuator [E].
10.
Position the eccentric pin [F] so that it aligns with the 9 o'clock posi-
Tighten the clutch hub (2 Allen screws).
tion.
11. Reassemble and check operation.
3-55
12 July '86
been replaced,